Algolaser 10W ALML10 Laser Head Lenses Kit x 2 with Tool

Kit of 2 Algolaser ALML10 replacement lenses for the 10W laser head, with changing tool and o-ring. A dirty or marked lens loses power: with a spare at hand, your engraver cuts and engraves like new again in minutes.

Will it fit my machine?

It's for Algolaser 10W laser heads. Check if yours is on the list:

Algolaser DIY Kit MK2 10W · DIY Kit 10W · Alpha 10W · Alpha MK2 10W
Lens code: ALML10

It does not fit heads of other power ratings. Don't see your model or have doubts? Message us on WhatsApp before buying and we'll confirm.

What's included

• 2 ALML10 lenses.
• 1 lens changing tool.
• 1 o-ring (rubber ring).

Why change the lens

• Get your power back: smoke and resin build up on the lens and block part of the light. With a clean lens, the full laser reaches the material.
• High-transparency material: less energy loss through the lens.
• Two units: replace one and keep the other as a spare so production doesn't stop.

Why buy it at Kennen

• Genuine Algolaser spare part with local stock.
• Kennen technical service in Argentina: if you prefer, we'll replace it for you.
• Technical support on WhatsApp before and after your purchase.

FAQ

How do I know it needs replacing? If the machine cuts or engraves weaker than before with the same settings, or if the lens looks stained, cloudy or has burn spots.

Can I clean it instead of replacing it? If it only has dust or smoke, yes: with a cotton swab and isopropyl alcohol, with the machine off. If it has marks or burns, it must be replaced.

Is it hard to change? No. With the machine off and unplugged, unscrew the lens with the included tool and fit the new one with its o-ring.

Algolaser is a trademark of its respective owner and is mentioned to identify the product and its compatibility.